Need help?Do you have a question about the dbx DriveRack PX and is the answer not in the manual?
Connect mixer, speakers, subs, and power up the DriveRack PX.
Select speaker models and adjust main/subwoofer levels.
Perform Auto Level, Auto EQ, and AFS for optimal sound tuning.
Store the created preset and assign it a unique name.
Connect hardware and load a saved preset into the DriveRack PX.
Re-configure Auto Level, Auto EQ, and AFS for the loaded preset.
Save any adjustments made to the loaded preset.
Analog Inputs| number of inputs | 2 (Stereo) Line inputs |
|---|---|
| RTA mic input | 1 |
| connectors | 2 Female XLR Line inputs, 1 XLR RTA Mic input |
| type | Electronically balanced, RF filtered |
| impedance | greater than 40kΩ |
| max input line level | +20dBu |
| input CMRR | greater than 45dB |
| RTA Mic Phantom Voltage | +15VDC |
| RTA Mic EIN | less than -110dBu, 22Hz-22kHz, 150Ω |
Analog Outputs| number of outputs | 2 (Stereo) Line outputs, 2 Sub outputs |
|---|---|
| connectors | 2 Male XLR Line outputs, 2 Male XLR Sub outputs |
| type | Electronically balanced, RF filtered |
| impedance | 120 Ω |
| max output level | +20dBu |
A/D Performance| type | dbx Type IV conversion system |
|---|---|
| dynamic range | 110dB A-weighted, 107dB unweighted |
| type IV dynamic range (transient material, A-weighted, 22kHz BW) | 123dB |
| type IV dynamic range (transient material, unweighted, 22kHz BW) | 121dB |
| dynamic range (program material, A-weighted, 22kHz BW) | 115dB typical |
| sample rate | 48kHz |
D/A Performance| dynamic range | 112dB A-weighted, 110dB unweighted |
|---|
System Performance| dynamic range | 110dB A-weighted, 107dB unweighted |
|---|---|
| THD+N | 0.002% typical at +4dBu, 1kHz, 0dB input gain |
| frequency response | 20Hz – 20kHz, +/- 0.5dB |
| interchannel crosstalk | less than -110dB, -120dB typical |
| crosstalk input to output | less than -100dB |
To Next Page
