14
USING YOUR WATER DISPENSER – ICE & WATER MODELS ONLY
TO ENSURE YOUR APPLIANCE OPERATES CORRECTLY PLEASE REFER TO THE
INSTALLATION INSTRUCTIONS BOOKLET SUPPLIED WITH THIS PRODUCT.
Before using your water dispenser
Ensure your ice and water system has been correctly installed by following the
installation instructions booklet supplied.
To flush the water filtration system:
Ensure your refrigerator is switched on, and the isolation
faucet has been connected and turned on.
Run your water dispenser pad until water dispenses, this
will displace trapped air in the water tank and filter system.
This will take at least 2minutes. Once water has dispensed,
rest the dispenser pad for 2minutes.
Dispense and discard 4qt (4L) of water, then rest the
dispenser pad for a further 2 minutes.
Dispense and discard a further 4qt (4L) of water. Failure to
do this will result in excessive dripping from your dispenser.
Please note, once installation is complete a few drips may
appear out of the dispenser over the next few days to clear
the remaining trapped air.
Ensure your refrigerator has cooled for at least 2 hours
before use.
You are now ready to enjoy water from your water dispenser.
Dispensing
Your water dispenser has been designed for one-handed operation.
To dispense water, gently press the dispensing pad using a glass or container.
To stop the flow of water, simply pull your glass away from the dispensing pad.
Please remember that pressing very hard against the dispensing pad will not encourage
the dispenser to operate faster or produce greater quantities of water.
IMPORTANT!
To avoid damage to property or personal injury do not put hands, fingers or objects
up the dispenser opening.
Dispenser lock
The dispenser lock located on the external display can be
activated to prevent water from being dispensed. This is
useful when you are cleaning the external display or when
there are small children around.
To activate dispenser lock press the button for 4seconds.
The LED above the button will illuminate.
When the dispenser pad is pressed several beeps will sound
indicating to the user that water cannot be dispensed.
To deactivate dispenser lock and allow water dispensing,
press the button for 4seconds. The LED above the button
will no longer illuminate.
Dispenser lock
Water dispenser
To Next Page
Loading...
Need help?
General
