Dea ADVANCE - Product Specifications and Contents; Models, Package Contents, and Transport; Technical Data

20
2 PRODUCT DESCRIPTION
2.1 Models and contents of the package
The name ADVANCE, identi• es a family of 24V electro-mechanical operators for the automation of hinged, up-and-over and sectional
doors. All motorised models use control units (NET series) that are equipped with anti-crushing sensor, incorporated 433 MHz radio
receiver, speed adjustment and deceleration on opening and closing.
ADVANCE models are speci• cally designed for semi-intensive residential use depending on the duty cycle envisaged for the automa-
tism.
The accompanying accessories are shown in the “PRODUCT ACCESSORIES” table (page 150).
ADVANCE is mainly composed of a mechanical operator that rotates a pinion which transmits motion directly to the drive of the door
via chain, thus allowing movement.
Inspect the “Content of the packaging” (Fig. 1) comparing it with your product; this may be useful during assembly.
2.2 Transport
ADVANCE is always delivered packed in boxes that provide adequate protection to the product, however, pay attention to all informa-
tion that may be provided on the same box for storage and handling.
3 TECHNICAL DATA
ADVANCE
Motor power supply voltage (V) 24 V
Absorbed power (W) 120
Max Thrust (N) 500
Work cycle 20 cycles/hour
Maximum n° of operations in 24 60
Operating temperature range (°C) -20÷50 °C
Opening speed (m/min) 5,3
Weight of product with package (Kg) 13
Protection degree IP20
NET724N
Power supply (V) 230 V ~ ±10% (50/60 Hz)
Rated power transformer (VA) 80 VA (230/22V)
Fuse F1 (A) T1A 250V (retarded)
24V operator output max 5 A
Auxiliaries power supply output 24 V
max 200mA
Confi gurable Output 1 24 V
max 5 W
Confi gurable Output 2 24 V
max 5 W
Receiver frequency 433,92 MHz
Transmitters type of coding HCS • x-code - HCS rolling code - Dip-switch
Max remote controllers managed 100
CONTROL BOARD
OPERATOR