Dea ADVANCE - Advanced Configuration Settings; Input Status, Counters, and Coding Selection; Operating Parameter Adjustments

26
8 ADVANCED PROGRAMMING
Below • nd the description of some programming procedures relative to the management of the radio-commands memory and advan-
ced con• guration of the command inputs.
To access the control unit advanced programming functions, remove the Jumper J4 from the board. Use the and keys to go to
P005 and hold the
key down for 5 seconds (at this point, all of the parameters are visible and can be modi• ed).
1 Visualisation of inputs and operations-counter status
1. Scroll the parameters with the and keys until the screen reads
P013;
2. Access the parameter by pressing the button;
3. The “Input Status” is shown on the screen (check that this is correct):
4. Press the button again;
5. The “Total Operation Counter” is shown on the screen
(* see P064):
Ex:
= 3x1000* = 3000 operations executed
6. Press the
button again;
7. The “Maintenance Operation Counter” is shown on the screen (* see
P065):
Ex:
= 5*x500 = 2500 operations still to be carried out before
the maintenance intervention request (
= maintenance operation
counter disabled)
8. Press the
button again to exit the parameters (P013 is shown on the
screen again).
2 Transmitters coding selection
1. Scroll down the parameters with and keys until you visualise
P027;
2. Con• rm by pressing on the key;
3. Select the type of transmitter by scrolling
and keys:
- d000=• x rolling-code (suggested);
- d001=complete rolling-code;
- d002=dip-switch;
4. Con• rm by pressing on the
key (display shows again P027).
Warning: If you need to vary the type of encoding, and only if other remo-
tes with different encoding are memorized, you need to erase memory
(P004) AFTER you have set the new encoding.
3 Adjustment of operating parameters
If you need to modify the operating parameters (force, speedness
etc..):
1. Scroll down the parameters until you visualize the desire param-
eter (i.g. P032);
2. Con• rm by pressing on the
key;
3. By pressing on
and , set up the desired value;
4. Con• rm by pressing on the
key (display shows the parameters
previously selected).
For the complete list of the “Operating Parameters” See the
table on page. 33.