392
14
Next, place the sticker on a
cutting mat and use a craft knife
to carefully trim down the excess, so
that you are left with the RENAULT
sticker alone.
15
Carefully remove the sticker from
its backing sheet.
11
Next, t the narrower end of
the air lter pipe over the base
of the air lter.
12
Your assembly should now look
like this.
16
Place the sticker onto the visor
section of the helmet cover and
press it into place. Do this gradually from
one side to the other, so that no creases or
air bubbles form. You may nd it easier to
remove the air lter pipe tted in Step 11
while you apply the stickers.
13
Very carefully cut out sticker 1
from the sheet, using scissors.
Make sure that you don‘t cut into any of
the other stickers as you do this.
To Next Page
Loading...
