DECATHLON SERIES GAS FRYERS
CHAPTER 1: SERVICE PROCEDURES
1-19
1.7.4 Replacing the High-limit Thermostat (cont.)
7. Carefully pull high-limit capillary tube and bulb out
of the frypot from the bottom.
8. Mark and disconnect wires at the high-limit in the
component box.
Remove high-limit capillary tube and bulb
from the bottom of the frypot.
Mark and disconnect high-limit wiring
(arrows). Reconnect wires to the same
terminals on the replacement high-limit.
PDF compression, OCR, web optimization using a watermarked evaluation copy of CVISION PDFCompressor
To Next Page
Loading...
