4.2.1
4.2.4
4.2.3
4.2.2
4.2.5
PNEUMATICHE
serie
BOXER
BOXER rev. 06 - 20
ORIGINALI
DEBEM s.r.l. - Via Del Bosco, 41 - Busto Arsizio (VA) ITALY
Tel. (+39) 0331/074034 - fax (+39) 0331/074036 - info@debem.it - www.debem.com
POMPE PER L’INDUSTRIA
info@debem.it - www.debem.com
CHEMICAL / PAINTING / PRINTING / WATER TREATMENT / GALVANIC / TEXTILE / CERAMIC / AUTOMOTIVE / MECHANICAL / OIL & GAS
4.2.5
of
INDUSTRIAL PUMPS
www.debem.com
rev
4.2 TRANSPORT AND HANDLING
These operations are exclusively reserved for handling personnel equipped with adequate Personal Protective Equip-
ment (PPE) such as: protective gloves, safety shoes and protective clothing.
CAUTION: risk of tipping and crushing.
The load inside the packaging can be unbalanced, therefore, do not use lifting equipment and gripping points
other than those indicated on the packaging.
When the supply is received, check that the packaging and the pump are intact and have not been damaged,
then:
Raise the supply using hoists of adequate capacity for the weight, respecting the instructions on the packaging.
With slow movements, handle the supply and transport it keeping it at a minimum height from the ground and
place it near the place of installation (dry and covered). Remove the hoist.
Open the packaging and take the use and maintenance manual and work as described.
CAUTION: danger of pollution.
Do not disperse the packaging into the environment, but contact specic authorised disposal companies.
Raise the pump using suitable loading equipment depending on the indicated weight.
Check that all the pump screws are tight, respecting the tightening torques shown in Section 6.3 TIGHTNESS
CHECK.
CAUTION: risk of stress corrosion cracking phenomena and breakages.
Excessive tightening (especially on plastic pumps), can cause dangerous tensions on some components
and sudden breakages that cannot be attributed to construction defects.
If the pump has been shipped with the air discharge silence disassembled, provide for its assembly.
CAUTION: risk of chemical reactions to water
Before installing the pump for use with liquids that react with tap water, it is necessary to open the product
circuit and dry all internal surfaces.
Raise the pump and move it to the place of installation.
Pump handling is complete.
To Next Page
