of
INDUSTRIAL PUMPS
www.debem.com
rev
1.3 INTRODUCTION
The Original Instructions have been developed taking into account all sizes and the different supply con-
gurations of the BOXER series Pneumatic Pumps, and the steps necessary for correct installation and
safe use.
This manual is an integral part of the pump and represents a safety device with which the Manufacturer
intends to provide important information so that the Purchaser and his/her personnel can install, use and
maintain it constantly efcient and safe.
The processed information is aimed at pursuing the highest level of safety for the environment, the
exposed people and the technicians qualied for the operations foreseen by the Manufacturer.
CONSULTATION AND PRESERVATION
The Manufacturer’s Original Instructions must be kept in good condition and must always be available for
consultation by the Technicians qualied to intervene on the machine in which it will be installed.
On the contrary, the Manufacturer is relieved of any liability with regard to:
• Incorrect installation;
• Incorrect or missing assessments of chemical compatibility with the uid to be pumped;
• Incorrect or missing assessments of classication of the potentially explosive environment and of suitability
for pump use according to the afxed Certication marking and the Declaration of Conformity;
• Improper use of the pump and/or for performances other than those declared;
• Use with higher temperatures than those declared by the Manufacturer;
• Interventions and/or use of the same by untrained personnel;
• Use contrary to the Manufacturer’s safety rules;
• Serious deciencies in maintenance;
• Changes or interventions not authorised by the Manufacturer;
• Use of non-original spare parts and/or unsuitable parts for the pump;
• Total or partial non-compliance with the Manufacturer’s Original Instructions.
RECIPIENTS OF THE ORIGINAL INSTRUCTIONS
This Original Instructions manual is addressed to all Operators and Technicians qualied to transport,
handle, install and maintain and/or repair the pump.
All Operators and qualied Technicians who interact with and intervene on the pump must be aware of
the intervention procedures established by the Manufacturer, of the residual risk present and of the safety
measures that must be adopted to prevent dangerous situations, and any damage that may arise for
exposed people, operators, for the environment and for property in general. In particular, Operators must
be aware of all personal protective equipment to be used during interventions that require working near
potentially dangerous areas.
The contents of this manual must be strictly followed.
LIMITS OF THE ORIGINAL INSTRUCTIONS
Please note that the instruction manual cannot replace the adequate knowledge and technical prepa-
ration of the installer or maintenance technician. This Manual provides information and instructions on
installation and maintenance that do not intend to replace or modify any general or specic standard,
requirement or law concerning safety and use, which affects the machine on which the pump will be
installed.
UPDATES TO THE ORIGINAL INSTRUCTIONS
The manual reects the state-of-the-art and technique at the time of marketing the pump and cannot be
considered inadequate only because it is not updated on the basis of any and future technical achieve-
ments.
The Manufacturer reserves the rights to update production and the manual without prior notice, and with-
out obligation to update the previously issued documents.
To Next Page
Loading...
