RUNNER 12
IMPORTANT SAFETY WARNINGS
ATTENTION !
• Circulation on sloping sections
Do not use the machine on slopes exceeding that indicated by the Manufacturer. While working
on slopes,, follow the rules given below:
1) Drive the machine slowly and carefully while going up and down the slopes;
2) Take care while steering and reversing the machine on slopes. Avoid excessively sudden
steering and reversing.
3) Operate the machine carefully while working close to ramps, pavements and trap-doors.
A minimum distance at least equal to the width of a wheel must be maintained from the edge.
• Transport in lifts and elevators
1) Before getting the machine into a lift or an elevator, make sure the latter can stand the total
weight of the machine with driver.
2) Move the machine close to the lift or elevator slowly and enter only when the lift or elevator is
level with the floor.
3) After the machine has entered the elevator, turn the relative controls to zero, disconnect the
power supply and apply the parking brake.
• Parking
1) When the machine is parked unmanned, turn the relative controls to zero, disconnect the
power supply, apply the parking brake, and block all accidental, unauthorized movement of the
trolley.
2) When parking the machine, avoid obstructing the entrance and safety exists, stairs, and fire
fighting equipment.
3) Do not park the machine on a slope.
• RECHARGING or replacing the accumulator batteries
ATTENTION: DANGER OF EXPLOSION!
The batteries give out hydrogen while working, and mainly during charging: this gas is highly
explosive in the presence of naked flames.
1) Battery recharging and replacement must be done by specially designated trained qualified
personnel, according to the battery manufacturer’s or the machine manufacturer’s instructions.
These operations can be carried out by the machine driver after prior authorization.
2) Before proceeding with replacement or recharging the battery, position the machine
correctly, apply the parking brake and remove the key from the power switch.
3) While charging the battery, leave the element caps in place to prevent splashing of
electrolyte. Make sure the caps bleed regularly.
4) The battery compartment cover must be kept open to allow dispersion of gas and heat.
5) Avoid the presence of naked flames, sparks and electric arcs in the areas meant for the
battery recharge. Do not smoke.
To Next Page
Loading...
General