5 Operating Servo model
64
5.8.5 Error Codes
When reading failure occurs in the Service window, an error code may appear in the lower part of
the error message. Check the details of the code using the table below.
Error Code Probable Cause
0x80000000 Timeout
0x80000001 Cancellation
0x80000002 Not Connected
0x80000003 Transmission Failure
0x80000004 Sequence Error (incoming message check)
0x80000005 Size Error (incoming message check)
0x80000006 Checksum Error (incoming message check)
0x80000007 SUB File Read Error (currently not in use)
0x80000008 Unidentied Error (COM not found, etc.)
0x80000009 Incorrect Data Quantity (when receiving a large quantity of data)
0x8000000a Other than the above
Servo model
To Next Page
Loading...