3
IMPORTANT
Please note: when you open the carton
carefully check the unit and make sure there
is no damage. If you have any problems with
the unit, with how the various functions
work, or damaged or missing parts please
call 1-800-459-4409 (8:30 am to 5:00 pm,
EST) immediately for service.
NOTE: DO NOT RETURN UNIT TO
THE STORE BEFORE CALLING THE
TOLL FREE NUMBER.
Do not dispose of your cartons until you
are completely satisfied with your new
stove heater.
NOTE: Light bulbs may become loose
during shipping. If the flame effect is dim
or does not work, please check that light
bulb or bulbs are finger tight in socket.
See instructions for replacing bulb or bulbs.
Please do not return the sample to the store
before checking light bulbs.
NOTE: The stove may emit a slight harmless
odor when first turned on. This is caused by
activating the internal heater components for
the first time and should not occur again.
A 15 AMP circuit is required to operate this
heater. If the breaker trips when the heater
is used then you may need to move the heater
to another location or unplug other appliances
that are on the same circuit. If you require
an extension cord, use one that is rated at
1875 watts.
SAFETY INSTRUCTIONS / OPERATION
LEG ASSEMBLY
Before using your unit please install the legs
as shown in diagram below.
After completely reading instructions,
confirm that all controls on stove are in the
OFF position. Plug the unit into a 15 amp,
120 volt outlet.
OPERATION
Controls and switches are located on front
panel inside the glass door.
I/O: Press this button into the “I” position for
main power and flame effect. The indicator
light will turn on.
HEATING: For heat function, press this
switch while the O/I switch is in the “I”
position for heat. The indicator light will
turn on.
To Next Page
