Cleaning and maintenance
1. Take out the dust collector, pull
out the HEPA filter and the filter
mesh, rinse with water and dry
naturally. It is recommended to wash
the HEPA filter at least once a
month.
2. If the hair is wound on the
roller of the air brush*, remove
the brush, press the special
button and remove the roller for
cleaning.
3. Remove the hair along the
axis of the roller, rinse it with
clean water and dry it naturally,
then install it back.
Additional Information
1. Before cleaning the product, make sure that the power of the
device is turned off;
2. If the device is not used for a long time, it should be stored in a
dark, cool and dry place. Do not place the device under direct
sunlight or in a humid environment;
3. Do not disassemble and repair the device yourself;
4. For cleaning, the device should be wiped using a dry wrung out
cloth. Do not use gasoline, alcohol, thinner or other chemicals,
otherwise cracking or discoloration of the case is possible;
5. To ensure the best cleaning result and long service life of the
electric motor, you should clean the dust collector and dust
filter in a timely manner. In case of damage, the filter should be
replaced immediately;
6. The filter can be washed with water. Before installation in the
device, it is necessary to make sure that it is completely dry
(Avoid drying in the sun), otherwise it may have a detrimental
effect on performance;
7. After use, brushes may retain hair or dust accumulations and
other large contaminants that should be removed immediately
for best cleaning results.
Roller
brush
Button
Brush axis
To Next Page
Loading...
