Returning for Service
Before returning the instrument for service…
1. Install new or newly recharged batteries in the proper
alignment as shown within battery compartment.
2. Examine the probe for damage. Use the supplied cleaning
tool to clear dirt or debris from the test cell.
3. Perform a Hard Reset (pg. 9).
4. If issue is not resolved, Update (pg. 14) your PosiTector
gage body and re-attempt measurements.
Limited Warranty, Sole Remedy
and Limited Liability
w ww . . co m
information@itm.com1.800.561.8187
To Previous Page
Loading...
Need help?
General
