10
Operation (continued)
3
Adjust the head
□ To adjust the light positioning vertically up to 60 degrees,
slowly push the xture head up or down to the desired
lighting location. To adjust the light positioning horizontally
up to 150 degrees, slowly push the xture head left or right
to the desired lighting location.
Battery Replacement
If the LEDs appear to be dim, this is an indication that your batteries need to be replaced.
TO REPLACE THE BATTERIES
□ Loosen the fastening screw (CC) and remove the main unit from the mounting plate (D).
□ Remove the battery plate (E) and take out the drained batteries from the battery compartment, and replace with new batteries of
the same type. Be sure to insert the batteries in correct direction. The correct polarity is shown inside the battery compartment.
□ Put back the battery plate (E) and press the main unit back to the mounting plate (D), x it with the fastening screw (CC).
BATTERY PRECAUTIONS:
□ Use only the size and type of batteries specified.
□ Always purchase the correct size and grade of battery most suitable for the intended use.
□ Be sure to follow the correct polarity when installing the batteries as indicated in the battery compartment. Reversed batteries
may cause damage to the device.
□ Do not mix alkaline, standard (Carbon-Zinc), or rechargeable (Nickel Cadmium) batteries.
□ Replace all batteries of a set at the same time. Do not mix old and new batteries.
□ Clean the battery contacts and also those of the device prior to battery installation.
□ Do not dispose of batteries in fire. Batteries should be recycled or disposed of as per state and local guidelines
□ Remove batteries if drained or if product is to be left unused for an extended period of time.
To Next Page
Loading...
