3 HOMEDEPOT.com
Please contact 1-866-308-3976 for further assistance.
Pre-Installation
PLANNING INSTALLATION
Before installing the motion sensor, ensure that all parts are present (see Hardware Included on page 4). If any part
is missing or damaged, do not attempt to assemble, install, or operate this motion sensor.
Estimated installation time: 30 minutes
SPECIFICATIONS
Range
Up to 70 ft. (21 m) - Varies with surrounding temperature
Sensing angle
Up to 270°
Electrical load - incandescent
Up to 300 watt maximum (Up to 150 watt maximum per bulb
holder)
Power requirements
120 VAC, 60 Hz
Operating modes
Test, Auto, Manual
Time delay
1, 5, 20 minutes
DualBrite timer
Off, 3 hours, 6 hours, dusk-to-dawn
TOOLS REQUIRED
Phillips
screwdriver
Flathead
screwdriver
Pliers
Wire strippers/
cutters
Circuit tester Work gloves
Electrical tape Silicone sealant Ladder
Safety goggles
To Next Page
Loading...
