Delete
individual
User / Single-
entry Code(s)
・Delete individual User Code(s).
Press
[SET]
for 1
second.
Programming
Code (6
digits)
3 0
User Code /
Single-entry
Code (4-6
digits)
Delete
another code
Delete all User
/ Single-entry
Codes
・ Delete all User & Single-entry
Codes.
Press
[SET]
for 1
second.
Programming
Code (6
digits)
4 0
ADVANCED SETTINGS
Add
Single-
entry
Code(s)
・ Single-use User Code can
only be used once to unlock
the lockset.
・ Single-use User Code
capacity: 5 sets (4 digits).
Press
[SET] for 1
second.
Programming
Code (6
digits)
2 1
Single-
entry
Code (4
digits)
Add
another
code
Vacation
Mode
・ Vaction mode temporarily
disable ALL User Codes.
Press
[SET] for 1
second.
Programming
Code (6
digits)
5 0
Turn
On
Turn
Off
1
0
Volume
Control
・ Turn on / off door lock
operation volume.
・Volume is always on in the
programming mode.
Press
[SET] for 1
second.
Programming
Code (6
digits)
6 0
Turn
On
Turn
Off
1
0
Auto-lock
・ Auto-lock is disabled by
default.
Press
[SET] for 1
second.
Programming
Code (6
digits)
8 0
Turn
On
Turn
Off
1
0
Auto-lock
Delay
Timer
・ Default Auto-lock Delay
Timer : 10 seconds.
・ Auto-lock Delay Timer
range: 10 -99 seconds.
Press
[SET] for 1
second.
Programming
Code (6
digits)
7 0
Enter
New
Amount
(10 - 99)
・The lockset will exit the programming mode and resume to the stand-by status if no input is
made in 10 seconds. ・3 Beeps means something was entered incorrectly. Please redo the step
again.
TROUBLESHOOTING
Your experience on this site will be improved by allowing cookies. Allow cookies
To Next Page
Loading...