Page 21
Gas Jet Cleaning Procedure
• Every six months the gas jets on your hob should
be cleaned to ensure continued efficient and safe
operation.
• This may be done using a Gas Jet Cleaning Kit
which may be purchased from your nearest Defy
Service Centre.
• The kit comprises of a sliding T-bar (A) a socket
(B) and a ‘Classic pin’ (C).
• Fit the T-bar to the socket and remove the pot
stands, burner caps and burner bodies.
1. Insert the socket into the central tube of the burner
so that it locates over the brass gas jet at the
bottom of the tube.
2. Gently loosen the brass gas jet by turning the
socket in an anti-clockwise direction.
3. Carefully lift the socket and loosened brass gas jet
from the central burner tube.
4. Insert the Classic pin into central hole of the jet
and slide it up and down until the jet is free of
accumulated dirt.
5. Re-assemble in reverse order.
6. Clean all the burner jets in the manner described
above.
Do not use any harsh abrasive cleaners
or sharp metal scrapers for cleaning the
oven door. They may scratch the
surface and destroy the glass.
The front door inner glass is coated
with an easy clean material. Do not use
any harsh abrasive cleaners, hard
metal scrapers, scouring pads or
bleach to clean the front door inner
glass as they may scratch the surface
and destroy the coating material.
Cleaning the oven door
To clean the oven door, use warm water with washing
liquid, a soft cloth or sponge to clean the product and
then wipe it with a dry cloth.
Removing the Oven Door Glass
Inner glass can be removed for cleaning.
A. Press clips on both ends of the top décor.
B. Lift the top décor & remove from door.
C. Lift the glass to a 45 degree position and pull
towards yourself. Clean the glass as per the
instructions.
A
C
B
To Next Page
Loading...
Need help?
General