CONDITION ACTION NOTES AND COMMENTS
Requires routine cleaning Mild detergent solution ap-
plied with soft sponge or
cloth. Rinse and wipe dry.
If possible use warm to
hand-hot water. A 5% addi-
tion of ammonia is benefi-
cial.
Finger prints Pre-treat finger marks with
alcohol or an organic sol-
vent. Follow immediately
with routine cleaning
Minimize re-occurrence by
applying a wax or silicone
based household polish to
the clean dry surface
Wipe with a little baby oil
and a soft lint free cloth.
Buff to shine
Apply whenever necessary
Stubborn stains and
discolouration
Use a little Ceran cleaning
paste. (available from Defy
Service Centres)
Rinse and dry.
Repeat several times rather
than resorting to a single
aggressive cleaning method
Grease and fat splatter. Wipe off excess with a soft
cloth or paper towel. Use a
water borne degreasing
agent ( dishwashing liq-
uid ).Follow up by routine
cleaning.
Scratches on the brushed fin-
ish.
For slight scratches, use a
nylon pad loaded with an
iron free abrasive polishing
compound. Follow the direc-
tion of the original texture.
Follow up with routine
cleaning.
For deep scratches use a
coarser abrasive initially and
follow up as for light
scratches.
Deep scratches will be diffi-
cult to remove completely.
Do not use steel wool or
metal scourers unless they
are made from stainless
steel.
It must be appreciated that some of the above suggested procedures will alter the
surface appearance of the treated area.
They should therefore only be applied with due consideration and care.
To Next Page
Loading...
Need help?
General
