Page 9
Note: AUTO air speed is not
available in FAN mode
3. Speed
x Press this button in order to be able to
select the fan speed as follows:
Low - Mid - High - Auto
4. Display
x Press this button to turn on/off the display.
This is for the convenience of users who
are unconformable sleeping with the
backlight on.
5. Zone Follow
x Press this button to set the temperature
display on the remote controller to
ambient temperature and press this
button again to set it to pre-set
temperature.
6. Timer
x With the unit ON, press this button to set
OFF timer or with it OFF to set ON timer.
x Press this button once, “ON(OFF)” will
flash. Press “ a ” or “ b ” to set the
number of hours in which the unit will be
switched ON/OFF, with an interval of 0.5 h
if less than 10 hrs., or 1 hour if longer than
10 hrs. , and a range of 0.5-24 hrs.
x Press it again to confirm the setting, the
“ON (OFF)” will stop flashing.
x If the timer button is not pressed longer
than 10 seconds after the “ON (OFF)”
flashes, the timer setting will exit.
x If a timer setting is confirmed, pressing
this button again will cancel it.
Note: The remote controller will
display all symbols during power-on
and only those corresponding to the
current operation will be displayed
relating to the particular function for
the rest of the time.
1. On/Off
x Press this button to turn on/off the unit.
x This will clear the existing timer and
SLEEP settings.
2. Temp
x Press this button to set the temperature
display to Fahrenheit, which is displayed
by default in Celsius. The “°C” will not be
displayed on the LCD.
x Press this button again to restore the
temperature display to Celsius.
Note: Temperature display in
Fahrenheit is not available for some
models. When temperature is
displayed in Fahrenheit on the
remote controller, it might be in
Celsius on the unit, the function
and operation of which will not be
affected.
To Next Page
Loading...
