18 / EN
Washing Machine / User’s Manual
4.3.12 Progress of programme
Progress of a running programme can be followed from the Programme Follow-up indicator. At
the beginning of every programme step, the relevant indicator light will turn on and light of the
completed step will turn off.
You can change the speed settings without stopping the programme flow while the programme is
running. To do this, the change you are going to make must be in a step after the running programme
step. If the change is not compatible, relevant lights will flash for 3 times.
C
If the machine does not proceed to the spinning step, the Rinse Hold function might be active or the automatic
unbalanced load detection system might be activated due to the unbalanced distribution of the laundry in the
machine.
4.3.13 Loadng door lock
There is a locking system on the loading door of the machine that prevents opening of the loading
door in cases when the water level is unsuitable.
loading door can be opened within 1-2 minutes.
current programme. See. "Cancelling the programme"
4.3.14 Changng the selectons after programme has started
Switching the machine to pause mode
Press the Start / Pause button to switch the machine to pause mode while a programme is running.
The light of the step which the machine is in starts flashing in the Programme Follow-up indicator to
show that the machine has been switched to the pause mode.
Changing the speed settings
You can change the speed settings of the programme that is currently running. See "Speed
selection".
C
If no change is allowed, the relevant light will flash 3 times.
Adding or taking out laundry
You can load/unload laundry when a programme is running if the water level is appropriate to open
the door. To do this:
1. Press Start / Pause button to switch the machine to pause mode. The programme follow-up light
of the relevant step during which the machine was switched into the pause mode will flash.
6. Press Start / Pause button to start the machine.
To Next Page
