Page 21
DANGER: Before replacing the oven
lamp, ensure that the appliance is
disconnected from mains and cooled
down to avoid the risk of an electrical
shock. Hot surfaces may cause burns!
The oven lamp is a special electric light
bulb that can resist up to 300°C. See
Technical specifications for details. Oven
lamps can be obtained from Authorised
Service Agents.
Position of lamp might vary from the
figure.
Replacing the oven light bulb
If your oven is equipped with a square lamp:
1. Disconnect the product from mains.
2. Remove the wire racks as described. See
Cleaning the oven.
Oven light
The oven light is switched on by the multifunction
selector switch and switches off when the knob is
returned to 0.
3. Remove the protective glass cover with a
screwdriver.
4. Unscrew oven lamp and replace it with
new one.
5. Install the glass cover and then the wire
racks.
1 Innermost glass panel
2 Inner glass panel
3 Outer glass panel
4 Plastic glass panel slot-Lower
As illustrated in figure, raise the innermost glass
panel (1) slightly in direction A and pull it out in
direction B. Repeat the same procedure to remove
the inner glass panel (2).
The first step to regroup the door is reinstalling inner
glass panel (2). As illustrated in figure, place the
chamfered corner of the glass panel so that it will rest
in the chamfered corner of the plastic slot.
Inner glass panel (2) must be installed into the plastic
slot close the innermost glass panel (1). When
installing the innermost glass panel (1), make sure
that the printed side of the panel faces towards the
inner glass panel. It is important to seat lower corner
of inner glass panel into the lower plastic slot. Push
the plastic part towards the frame until you hear a
"click".
If your oven is equipped with a round lamp:
1. Disconnect the product from mains.
2. Turn the glass cover counter clockwise to
remove it.
3. Remove the oven lamp by turning it counter
clockwise and replace it with the new one.
4. Install the glass cover
To Next Page
Loading...
