Screw Driving
1. Select the desired speed/torque range using the gear switch to match the speed and torque to
the planned operation.
2. Turn the torque adjustment ring to the desired position. Torque setting of 1-18 is for screw driv-
ing.
NOTE: Use the lowest torque setting required to seat the fastener at the desired depth. The lower
the number, the lower the torque output.
3. Insert the desired fastener accessory into the chuck.
4. Make some practice runs in scrap or on unseen areas of the workpiece to determine the proper
position of the torque adjustment ring.
5. Always start with lower torque settings, then advance to higher torque settings to avoid damage
to the workpiece or fastener.
Drilling
NOTE: If drilling thin material, use a wood “back-up” block to prevent damage to the material.
1. Turn the torque adjustment ring to the drill symbol . Select the desired speed by turning the
2-speed gear switch.
2. Always choose appropriate drill bits for different materials.
3. Always apply pressure in a straight line with the bit. Use enough pressure to keep drill biting, but
do not push hard enough to stall the motor or deflect the bit.
4. Hold tool firmly with both hands to control the twisting action of the drill.
WARNING: Drill may stall if overloaded, causing a sudden twist.
WARNING:
9
Charging input port
Battery and Charging
Note: The battery is supplied partially charged to prevent possible problems. Therefore, you should
charge it prior to use. Batteries will not reach full charge the first time they are charged. Allow
several charging/discharging cycles for them to fully charge.
WARNING Do not continue to press the On/Off switch after the machine has been automati-
cally switched off. The battery can be damaged. The battery is equipped with an NTC temperature
control which allows charging only within a temperature range of between 10°C-40°C(50°F-104°F).
A long battery service life is achieved in this manner. Observe the notes for disposal.
Use only original DEKO battery in conjunction with your DEKO power tool.
This measure alone protects the battery against dangerous overload. When
using other batteries, e.g.imitations, reconditioned batteries or other
brands, there is danger of injury as well as property damage through
exploding batteries.
Do not open the battery. Danger of short-circuiting may occur. Protect the
battery against heat, e.g., against continuous intense sunlight, fire, water,
and moisture. Danger of explosion may occur.
Use only original DEKO charger to charge
the battery. When the charger incdicator light is in red
color, the battery is under charging. when the charger light
turns green, the battery is fully charged.
The battery indicator indicates the battery voltage by LED
color: green for high battery and red for low battery.
WARNING:
WARNING:
full battery low battery
battery indicator
To Next Page
Loading...