Delem DA-52s - Page 14

V0812, 2.4
Punch. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .UP
Number of punch in library.
Die . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .UN
Number of die in library.
Bending length . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .BL
Length of sheet between tools.
When programming a bend, it is assumed the programmed tools have the necessary length.
2.c
Stock . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .ST
The number of products that should be created with this program.
G-Corr
α . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .Gα
General correction of the angle, valid for each bend of the program. The value should be
programmed in the same manner as for the correction per bend.
G-Corr X. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .Gx
General correction of the X-axis position, valid for each bend of the program. The value
should be programmed in the same manner as for the correction per bend.
E-MODULE
(N/mm²)
TENSILE
STRENGTH
(N/mm²)
1 = Steel
2 = Aluminium
3 = Zinc
4 = Stainless steel
5 = Material 5
6 = Material 6
210.000
70.000
94.000
210.000
210.000
210.000
400
200
200
700
400
400