V0812, 2.8
2.3.3. Bend parameters - second page
2.e
This page contains the additional parameters of a bend.
Force . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .P
The required force during pressing (auto computed).
This force is precomputed from the bend properties Material, Thickness, Bending length
and the V-opening of the die.
Speed . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .V
Working speed (pressing speed). Initially, the value for this parameter is copied from the
parameter ‘default pressing speed’ in the programming constants menu.
Dwell time . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .T
Holding time of punch at bending point.
Decompression. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .DC
Decompression stroke after bending to release the working pressure
Decomp speed . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .BS
The decompression speed is the programmable speed which is active during the
programmed decompression stroke.
Delay time . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .TX
Programmable delay time before step change (0-30sec).
To Next Page
Loading...
