Information Section
1.6 Intended uses
This particular model has been designed, constructed and equipped with safety devices for solid
dust and debris vacuuming applications only. The machine is provided with appropriate specific
anti-static filters to operate in explosive atmosphere areas (ETL LISTED).
WARNING!
Always use specific filters for the type of dust or materials to be vacuumed.
ATTENTION!
Utiliser toujours les filtres dédiés au type de poussières et de déchets à aspirer.
Any other use is considered
IMPROPER
.
The vacuum cleaner is in any case intended for professional industrial use.
1.7 Allowed environmental conditions
To ensure the correct operation of the vacuum cleaner, this must be positioned protected against
atmospheric agents (rain, hail, snow, fog, dusts in suspension, etc.) with an environmental running
temperature between 0°C and +40°C and relative humidity not above 70%.
The work environment must be clean, well-enough lit.
1.8 Noise level
The phonometric test results on this specific model correspond to the following acoustic
pressure values (at 1 meter distance from the vacuum. and at 1,60 mt. height, where there is the
most noisy part of the vacuum):
74 dB (A)
Hand-arm vibrations given by the vacuum are lower than 2,5 m/s2
1.9 Storage
Remove the filter and clean it, empty the container and store the vacuum cleaner in a place
protected against atmospheric agents with a temperature between 0°C and +40°C. Cover with a
nylon sheet to prevent accumulation of dust.
1.10 Scrapping
In case of scrapping, all the component parts of the vacuum cleaner will have to be disposed of
through adequate disposal channels in accordance with applicable legislation.
Before scrapping, all plastic and rubber parts will have to be separated from the electrical
material.
Parts made of plastic, aluminium and steel only may be recycled if collected by special centres.
To Next Page
Loading...
