SkinFibroMeter User Manual v 2.0
2.1.2018
11
TECHNICAL DATA
System components
o SkinFibroMeter measuring unit with integrated probe
o Batteries (installed)
o User manual (USB flash drive + printed)
o Carrying case
Accessories
o DMC data collection software (USB flash drive)
o Wireless receiver unit
o RoomSensor for recording ambient RH and temperature
Power supply
o 2 x 1.5 V AA alkaline battery (IEC: type LR6)
o Power consumption: 360 mW – 495 mW (Wireless mode on – off)
SkinFibroMeter measuring unit
o Dimensions: 189 x 45 x 35 mm
o Weight with batteries: 145 g
o Protection class: IP52
o Measurement completion time: 0.5 seconds
o Measurement repeat cycle 10 measurements per minute typically
o Measured parameter: Indenter force
o Measuring SI unit: N (Newton)
o Operating range: 0.01 – 1.25 N
o Force sensor accuracy: ±3 %
o Coefficient variation (SD/mean) measured on skin typically ≤10%
Integrated probe
o Indenter length: 1.25 mm
o Indenter diameter: 2.5 mm
o Indenter type: stainless steel (AISI 316L) with rounded tip
o Base plate diameter: 23 mm
o Base plate material: PTFE
o Maximum force applied to either the base plate or the indenter: 10 N
*
To Next Page
Loading...