8
Group Mode
The SkinFibroMeter is paired with the wireless receiver unit, which comes
together with the instrument. Select Group Mode, if other than the original
receiver unit is used with the DMC program and the SkinFibroMeter. See the
user manual of the DMC for further instructions.
Device info
Displays the software version, the manufacturing date, the serial number of
the device, the serial number of the programmed receiver unit and the
measurement counter.
RECOMMENDATIONS FOR MEASURING WITH THE SKINFIBROMETER
Skin surface
o Smooth and even skin site is the most reliable measurement site.
o Skin hair, scars and folds may prevent a good contact between the
probe and the skin.
o Skin surface should be dry.
o Avoid skin sites over superficial bones, tendons and large veins.
Environmental conditions
The SkinFibroMeter can be used in normal room temperature. Recommended
operating conditions are mentioned in the section
Technical data in this
manual.
Human related factors
Measurements with the SkinFibroMeter can be performed when the subject
has been resting for 5-10 minutes. Hot drinks and smoking should be avoided
for at least 60 min before measurements.
o Make sure that the tested person is totally relaxed before the
measurement. No muscle tension should occur.
o The tested person should be in the same position at every measurement
session during a study (e.g. sitting on the chair the arm resting on the
table, if an arm is measured).
To Next Page
Loading...