78 | Dell EMC VxRail Appliance Operations Guide
© 2017 Dell Inc. or its subsidiaries.
Credentials can be shared credentials across all ESXi hosts in the cluster, or each host can
have its own unique credentials. This dialog shows the host names and IP addresses that
will be assigned to the new nodes.
An example of this dialog is shown below.
Figure 43. VxRail Manager Cluster Expansion dialog – Host Details
DNS look-up records must be configured with IP addresses and hostnames before
continuing. Confirm that the DNS records have been configured by clicking the checkbox at
the bottom of the dialog.
6. Click Validate to continue.
7. If the validation succeeds, click Expand Cluster to add the new nodes.
Progress is displayed in the VxRail Manager Dashboard view. When complete, the new
nodes can be seen in the Cluster Health view.
8. Verify that the new nodes were added to the VxRail in the vCenter Hosts and Cluster view.
Note: Any additional network configuration that was not part of the initial VxRail Appliance
configuration must be manually added to this new node.
To Next Page
Loading...
