Need help?Do you have a question about the Dell EMC PowerEdge R620 and is the answer not in the manual?
General| Memory Slots | 24 DIMM slots |
|---|---|
| Processor | Intel Xeon E5-2600 or E5-2600 v2 |
| Chipset | Intel C600 series |
| Memory | Up to 768GB DDR3 (24 DIMM slots) |
| RAID Controller | PERC H710, PERC H710P |
| Network Controller | Intel X540 dual-port 10GbE |
| Power Supply | 750W, or 1100W |
| Operating System Support | Windows Server, Red Hat Enterprise Linux, SUSE Linux Enterprise Server, VMware ESXi |
| Form Factor | 1U Rackmount |
| Storage | Up to 10 x 2.5" drives or 4 x 3.5" drives |
Describes the front panel buttons, indicators, and connectors on the system.
Details the functionality and operation of the system's LCD panel.
Step-by-step guide for configuring iDRAC IP address using the LCD panel.
Explains the system's diagnostic indicators and their corresponding corrective actions.
Describes the status and activity patterns of hard drive indicators.
Details the connectors, ports, and indicators located on the back panel of the system.
Explains the different system boot modes (BIOS vs UEFI) and their configuration.
Details system security features including passwords, TPM, and AES-NI.
Explains the functionality and security implications of system and setup passwords.
Provides step-by-step instructions for assigning system and setup passwords.
Instructions for deleting or changing existing system and setup passwords.
Provides instructions on how to access the Unified Extensible Firmware Interface (UEFI) Boot Manager.
Introduction to the iDRAC (Integrated Dell Remote Access Controller) settings utility.
Provides the steps required to access the iDRAC settings utility.
Guidelines for installing, configuring, and understanding system memory.
Covers handling drive blanks, hot-swap drives, and installing/removing drive carriers.
Covers guidelines, removal, and installation of expansion cards and risers.
Covers removal and installation of processors and their corresponding heat sinks.
Details power supply installation, removal, hot spare feature, and DC wiring.
Instructions for safely removing and installing the system board.
Emphasizes critical safety precautions before performing any troubleshooting.
Guides on resolving issues that prevent the system from booting successfully.
Steps for diagnosing and resolving problems related to the system's power supplies.
Guides for diagnosing and resolving system memory errors.
Steps for diagnosing and resolving hard drive problems, including data backup.
Guides for diagnosing and resolving problems related to the system's processors.
Overview of the Embedded System Diagnostics (ePSA) for pre-boot system assessment.
Identifies and describes the various connectors present on the system board.
Instructions for clearing system or setup passwords using a jumper.
Details memory architecture, module types, sockets, and capacities.
Details supported hard drive types, interfaces, and configurations.
Lists and explains various system error codes, their details, and recommended actions.
Provides contact information and steps to access Dell support and service options.
To Next Page