Removing the integrated storage controller
CAUTION: Many repairs may only be done by a certied service technician. You should only perform troubleshooting and simple
repairs as authorized in your product documentation, or as directed by the online or telephone service and support team.
Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
1 Turn o the system, including any attached peripherals, and disconnect the system from the electrical outlet.
2 Open the system.
3 Push down on the two tabs at the edge of the card and lift the card o the extractors.
As the card releases from the standos, the connector under the card disengages from the system board connector.
4 Angle the card so that the other end of the card disengages from the storage-controller card holder on the system board.
5 Close the system.
Figure 33. Removing the integrated storage controller
1 storage connector on the system board
2 storage controller card
3 storage-controller card holder
4 extractors (2)
Installing and removing system components
65
To Next Page
Loading...
