Figure 10. Removing and installing the front bezel
1 release latch 2 keylock
3 front bezel 4 locking hook
Installing the front bezel
1 Hook the right end of the bezel onto the chassis.
2 Fit the free end of the bezel onto the system.
3 Secure the bezel with the keylock.
System cover
Opening the system
NOTE
: It is recommended that you always use an antistatic mat and antistatic strap while working on components inside the
system.
1 Turn o the system and attached peripherals, and disconnect the system from the electrical outlet.
2 Rotate the latch release lock counter clockwise to the unlocked position.
3 Lift the latch on top of the system and slide the cover back.
4 Grasp the cover on both sides and carefully lift the cover away from the system.
Installing and removing system components
35
To Next Page
Loading...
