Dell EMC PowerEdge R620 - Warning Messages; Diagnostic Messages

Error Code Message Information
Details Ambient air temperature is too cool.
Action Check the system operating environment.
TMP0120
Message The system inlet temperature is greater than the upper warning threshold.
LCD Message System inlet temperature is outside of range.
Details Ambient air temperature is too warm or one or more fans may have failed.
Action Check the system operating environment and review event log for fan failures.
TMP0121
Message The system inlet temperature is greater than the upper critical threshold.
LCD Message System inlet <name> temperature is outside of range. Check Fans.
Details Ambient air temperature is too warm or one or more fans may have failed.
Action Check the system operating environment and review event log for fan failures.
VLT0204
Message The system board <name> voltage is outside of the allowable range.
LCD Message System board voltage is outside of range.
Details System hardware detected an over voltage or under voltage condition.
If multiple voltage exceptions occur consecutively the system may power down in fail-
safe mode.
Action
1 Review system logs for power supply exceptions.
2 Re-congure the system to minimum conguration, inspect and reinstall system
cables.
3 If the issue persists, see Getting Help.
Warning messages
A warning message alerts you to a possible problem and prompts you to respond before the system continues a task. For example, before
you format a hard drive, a message warns you that you may lose all data on the hard drive. Warning messages usually interrupt the task and
require you to respond by typing y (yes) or n (no).
NOTE
: Warning messages are generated by either the application or the operating system. For more information, see the
documentation that shipped with the operating system or application.
Diagnostic messages
The system diagnostic utility generates messages if there are errors detected when you run diagnostic tests on your system. For more
information about system diagnostics, see the For information about the event and error messages generated by the system rmware and
agents that monitor system components, see the Error Code Lookup page, at qrl.dell.com.
System messages
129