System messages
Topics:
• LCD Messages
• System Error Messages
• Warning messages
• Diagnostic messages
• Alert messages
LCD Messages
NOTE: Applicable only if your system has an LCD display.
The LCD messages consist of brief text messages that refer to events recorded in the System Event Log (SEL). For information on the
SEL and conguring system management settings, see the systems management software documentation.
NOTE
: If your system fails to boot, press the System ID button for at least 5 seconds until an error code is displayed on the LCD.
Record the code, then see System Error Messages.
Viewing LCD messages
If a system error occurs, the LCD screen will turn amber. Press the Select button to view the list of errors or status messages. Use the Left
and Right buttons to highlight an error number, and press the Select button to view the error.
Removing LCD Messages
For faults associated with sensors, such as temperature, voltage, fans, and so on, the LCD message is automatically removed when that
sensor returns to a normal state. For other faults, you must take action to remove the message from the display:
• Clear the SEL — You can perform this task remotely, but you will lose the event history for the system.
• Power cycle — Turn o the system and disconnect it from the electrical outlet; wait approximately 10 seconds, reconnect the power
cable, and restart the system.
System Error Messages
System messages appear on the monitor to notify you of a possible problem with the system. These messages refer to events recorded in
the System Event Log (SEL). For information on the SEL and conguring system management settings, see the systems management
software documentation.
Some messages are also displayed in an abbreviated form on the system's LCD, if the system includes that feature.
NOTE
: The LCD error messages listed here are displayed in the simple format. See Setup Menu to select the format in which the
messages are displayed.
8
116 System messages
To Next Page
Loading...
