7-2 Dell PowerEdge 4100/180 and 4100/200 Systems Installation and Troubleshooting Guide
Removing the Computer Covers
Use the following procedure to remove the computer
covers:
1. Observe the Warning for Your Personal Safety and
Protection of the Equipment described earlier in this
chapter. Also observe the safety instructions at the
front of this guide.
2. To remove a computer cover, turn the cover’s
keylocks on the back panel of the computer (see
Figure 7-1) to the unlocked position.
Figure 7-1. Keylocks on the Computer’s
Back Panel
3. Loosen the three screws along the back edge of
the cover (see Figure 7-2).
4. Slide the cover forward an inch or so, grasp the
top of the cover at both ends, and lift it straight
away from the chassis.
To Next Page
Loading...
