Need help?Do you have a question about the Dell Brocade VDX 6740 and is the answer not in the manual?
General| Switch Type | Data Center Switch |
|---|---|
| Virtualization Support | Yes |
| Product Series | VDX |
| Power Supply | Dual, Hot-swappable |
| Jumbo Frame Support | Up to 9216 bytes |
| Management | CLI, SNMP, Web UI |
| Layer Support | Layer 2, Layer 3 |
| Operating Temperature | 32°F to 104°F (0°C to 40°C) |
| Storage Temperature | -25°C to 70°C (-13°F to 158°F) |
| Model | 6740 |
Describes the intended audience for this switch configuration guide.
Provides an overview of the switch configuration and specifications.
Illustrates the recommended method for deploying servers and EqualLogic arrays.
Steps for powering on, connecting serial cables, and initial setup.
Procedure to reset the switch to default configuration settings.
Commands to configure Port-channel 1 with specific settings.
Configuration steps for assigning ports to a Link Aggregation Group (LAG).
Disabling DCB TLV and iSCSI-APP TLV using LLDP protocol.
Commands to disable Ethernet Fabric ISL and trunk on edge ports.
Configuration to enable Jumbo MTU with a specific frame size.
Commands to configure ports as access switchports.
Configuring link level flow control for ports.
Setting up Spanning Tree Protocol (RSTP) and edgeport configuration.
Disabling LLDP, CEE, and iSCSI priority features.
Command to save the running configuration to startup configuration.
Instructions to repeat configuration steps for a second switch.
Fine-tuning switch buffers for optimal receive and transmit queues.
Command to set the VCS ID for the switch.
Command to set the Rbridge-ID for the switch.
To Next Page