Installing the intrusion switch
1 Insert the intrusion switch into the slot on the chassis [1].
2 Connect the intrusion switch cable to the system board [2].
3 Install the:
a Heat sink and heat sink fan
b Hard drive and optical drive module
c Front bezel
d Side cover
4 Follow the procedure in After working inside your computer.
Power switch
Removing power switch
1 Follow the procedure in Before working inside your computer.
2 Remove the:
a Side cover
b Front bezel
c Hard drive and optical drive module
3 To remove the power switch:
Removing and Installing components
45
To Next Page
Loading...
