Dell D29M - Removing the 2.5-Inch Hard-Drive Bracket

To Next Page

To Previous Page

Steps

1. Disconnect the hard-drive data and power cables from the connectors on the 2.5-inch hard-disk drive module.

2. Press the release tabs on both the sides of the hard-drive bracket to release it from the slots on the computer chassis.

3. Tilt the hard-drive assembly slightly at an angle.

4. Lift the hard-drive assembly from the computer.

NOTE: Note the orientation of the hard drive so that you can replace it correctly.

Removing the 2.5-inch hard-drive bracket

Prerequisites

1. Follow the procedure in before working inside your computer.

2. Remove the side cover.

3. Remove the fan duct.

4. Remove the 2.5 inch hard-drive assembly.

Removing and installing components

Other manuals for Dell D29M