Steps
1. Place the first hard-drive into the hard-drive metal bracket and align the slots on the bracket with the slots on the hard
drive.
2. Replace the two (M3x3.5) screws to secure the first hard drive to the hard-drive metal bracket.
3. Place the second hard drive into the hard-drive metal bracket and align the slots on the bracket with the slots on the hard
drive.
4. Replace the two (M3x3.5) screws to secure the second hard drive to the hard-drive metal bracket.
Next steps
1. Install the 2.5 inch hard-drive assembly.
2. Install the fan duct.
3. Install the side cover.
4. Follow the procedure in after working inside your computer.
Installing the 2.5-inch hard-drive assembly
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
20
Removing and installing components
To Next Page
Loading...
