Steps
1. Insert the hard drive assembly into the slot on the computer until it clicks into place.
2. For 2.5-inch hard drive set as secondary, connect the black hard drive data cable and power cable to the connectors on the
2.5-inch hard drive.
Next steps
1. Install the side cover.
2. Follow the procedure in after working inside your computer.
Installing the primary 2.5-inch hard drive assembly
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the 2.5-inch hard drive assembly and provides a visual representation of the
installation procedure.
22
Removing and installing components
To Next Page
Loading...
