Steps
1. Insert the hard drive assembly into the slot on the computer until it clicks into place.
2. Connect the hard drive data and power cables to the connectors on the 2.5-inch hard drive module.
Next steps
1. Install the 2.5-inch primary hard drive or 2.5-inch secondary hard drive.
2. Install the side cover.
3. Follow the procedure in after working inside your computer.
3.5 in. hard-drive assembly
Removing the 3.5-inch hard drive assembly
Prerequisites
1. Follow the procedure in before working inside your computer.
2. Remove the side cover.
3. Remove the front bezel.
Removing and installing components
23
To Next Page
Loading...
