62 Removing and Installing Parts
www.dell.com | support.dell.com
10
Gently slide the drive into place.
11
Once the drive is in place, apply pressure to ensure that the drive is fully seated.
12
Use the securing screw that came with the drive to attach the drive to the computer.
CAUTION: Match the colored strip on the cable with pin 1 on the drive (pin 1 is marked as "1").
13
Connect the power cable to the system board.
14
Locate the data cable from the CD or DVD drive in the upper drive bay and connect its
middle data connector to the new drive.
15
Check all cable connections, and then fold the cables out of the way to provide airflow for the
fan and cooling vents.
16
Reattach the front panel to the side hinges, and then rotate it until it snaps onto the front of
the computer.
drive
alignment screws (2)
securing
screw
extra alignment
screws (2 or 4)
To Next Page
Loading...
