30 Setting Up and Using Your Computer
Setting Your Computer to RAID-Enabled Mode
1
Enter system setup (see "System Setup" on page 107).
2
Press the up- and down-arrow keys to highlight
Drives
, and press <Enter>.
3
Press the up- and down-arrow keys to highlight
SATA Operation
, and press <Enter>.
4
Press the left- and right-arrow keys to highlight
RAID On
, press <Enter>, and then press <Esc>.
NOTE: For more information about RAID options, see "System Setup Options" on page 109.
5
Press the left- and right-arrow keys to highlight
Save/Exit
, and press <Enter> to exit system setup and
resume the boot process.
WD846bk2.book Page 30 Thursday, September 14, 2006 2:40 PM
To Next Page
Loading...
