96 Removing and Installing Parts
8
Insert the Media Card Reader and slide it into place until it is fully seated.
9
Route the FlexBay USB cable through the cable routing clip.
10
Replace the computer cover (see "Replacing the Computer Cover" on page 101).
CD/DVD Drive
CAUTION: Before you begin any of the procedures in this section, follow the safety instructions located in the
Product Information Guide.
CAUTION: To guard against electrical shock, always unplug your computer from the electrical outlet before
removing the cover.
Removing a CD/DVD Drive
1
Follow the procedures in "Before You Begin" on page 59.
2
Remove the computer cover (see "Removing the Computer Cover" on page 65).
3
Remove the drive panel (see "Removing the Drive Panel" on page 80).
FlexBay USB
cable
Media Card Reader
WD846bk2.book Page 96 Thursday, September 14, 2006 2:40 PM
To Next Page
Loading...
