90 Removing and Installing Parts
3
Disconnect the power and data cables from the back of the floppy drive.
NOTE: If you are installing a PCI Express x16 card, this card may cover the floppy-drive connectors. Remove this
card before connecting the floppy-drive cables.
4
Slide the drive latch release toward the bottom of the computer and, without releasing the drive latch
release, slide the floppy drive out through the front of the computer.
floppy drive
sliding plate
drive latch release
WD846bk2.book Page 90 Thursday, September 14, 2006 2:40 PM
To Next Page
Loading...
