3. Follow the procedure listed in Before working inside your system.
Steps
1. Remove the screw securing the control panel to the chassis.
2. Disconnect the control panel cable and the control panel USB cable from the system board.
CAUTION: Do not use excessive force when removing the control panel cables as it can
damage the connectors.
3. Slide the control panel out of the chassis.
4. Disconnect the cables from the control panel.
Figure 56. Removing and installing the control panel assembly
1. control panel 2. control panel cable
3. control panel USB cable 4. screw
NOTE: Follow the same steps to remove the control panel in the rack-mode configuration.
5. Locate and press the tabs on the information tag.
6. Push the information tag out of the slot to remove it from the control panel.
NOTE: Retain the information tag to replace it in the new control panel.
130
To Next Page
Loading...
