Steps
1. Using a screwdriver, push the release tabs on the four corners of the blank from inside the system, to
unlock the four-slot hard-drive blank from the chassis.
2. From the front of the system, pull the four-slot hard-drive blank at the corners until it is free of the
hard-drive slot.
Figure 33. Installing and removing the four-slot hard-drive blank
1. four-slot hard-drive blank 2. release tab
3. screwdriver
Related Links
Removing the cooling shroud
Removing the hard-drive backplane
Installing a four-slot hard-drive blank
Installing a four-slot hard-drive blank
Prerequisites
Ensure that you read the Safety instructions.
Steps
1. Locate the hard drive slots numbered from four to seven.
2. Insert the four-slot hard-drive blank into the hard-drive slot, and push it until the release tabs click
into place.
83
To Next Page
Loading...
