Next steps
Place the system upright on a flat and stable surface, and turn the system feet outward.
Related Links
Removing the system feet
Caster wheels (optional)—tower mode
Caster wheels provide mobility to the system in the tower mode.
The caster wheel assembly consists of:
• Caster wheel units (front and back)
• Two screws for the caster wheel units
Installing caster wheels
Prerequisites
1. Ensure that you read the Safety instructions.
2. Keep the #2 Phillips screwdriver ready.
3. Lay the system on its side on a flat and stable surface with the base of the system extending off the
edge of the surface.
4. If installed, remove the system feet.
Steps
1. Align the two retention hooks on the back wheel unit with the two slots on the base of the chassis,
and insert the hooks into the slots.
2. Offset the back wheel to the back of the system and secure the unit in place using a single screw.
3. Align the two retention hooks on the front wheel with the two slots on the base of the chassis and
insert the hooks into the slots.
4. Offset the front wheel to the front and secure the unit in place using a screw.
53
To Next Page
Loading...
