Dell E82S - Page 136

Figure 89. Configuration 13: 16 x 2.5-inch NVMe
NOTE: Follow the sequential order as shown in the table to remove the cables, to install the cables follow the reverse
sequential order.
Table 92. 16 x 2.5-inch NVMe
Order From To
1 SL2_CPU2_PA1 (signal connector on system
board)
BP_DST_PA1 (backplane signal connector)
2 SL1_CPU2_PB1 (signal connector on system
board)
BP_DST_PB1 (backplane signal connector)
3 SL5_CPU2_PB3 (signal connector on system
board)
BP_DST_PA2 (backplane signal connector)
4 SL6_CPU2_PA3 (signal connector on system
board)
BP_DST_PB2 (backplane signal connector)
5 SIG_PWR_1 (system board power connector) BP_PWR_1 (backplane power connector)
6 SL3_CPU1_PA2 (signal connector on system
board)
BP_DST_PA2 (backplane signal connector) and
BP_DST_PB2 (backplane signal connector)
7 SL4_CPU1_PB2 (signal connector on system
board)
BP_DST_PB1 (backplane signal connector)
8 SL7_CPU1_PB4 (signal connector on system
board)
BP_DST_PA2 (backplane signal connector)
9 SIG_PWR_2 (system board power connector) BP_PWR_1 (backplane power connector)
10 SL8_CPU1_PA4 (signal connector on system
board)
BP_DST_PB2 (backplane signal connector)
136 Installing and removing system components