Dell EMC Edge Gateway 5200 Service Manual

8. Secure the DI/O front panel to the main I/O panel. Use the two screws to the sides of the DI/O front panel and the two
screws on the bottom edge of the chassis. Use two screws to secure the module to the standoffs on the bracket, as shown
in the following figure.
Figure 104. DI/O module installed
9. Connect the DI/O cable. Use a cable tie, as shown with a red circle in the following figure.
Figure 105. DI/O cable with cable tie
Pin mappings are shown in the following figure and table.
58
Installation procedure for 8x DI/O uFM module

Dell EMC Edge Gateway 5200 Specifications

General

Brand	Dell
Model	EMC Edge Gateway 5200
Category	Gateway
Language	English