Figure 29. Installing a sled
2. Insert the sled into the enclosure. Using the sled handle, slide the sled and stop at 20-30mm before completing the insertion
of the sled as shown in the image below.
CAUTION:
To avoid any damage to the pins on the sled, do not force the sled into the enclosure. Follow the
two-position insertion and gently slide the sled into the enclosure.
Figure 30. Stop the sled at a distance of 20-30 mm before complete insertion
3. Using the sled handle, slide the sled until it locks into place.
Installing and removing system components
27
To Next Page
Loading...
